Create inward curving waterfalls. EWLR2 (1), EWI16 (3)

Create outward curving waterfalls. EWLR2 (1), EWO16 (3)

Use the pieces together to create an "S" shaped waterfall. EWLR3 (1), EWI16 (3), EWO16 (3)

Once installed, these spillways are hidden from view by rock.

Mix and match straight, inward and outward extensions to create all kinds of waterfall designs!

The 16" center module is available in straight sections or inward and outward curved sections allowing you to create curved waterfalls!  You can install as many of the 16" extensions as desired  before attaching the ends. 

Straight waterfall spillways of 18", 34" and 50" come assembled, curved spillways and spillways over 50" wide come unassembled due to shipping constraints. 

Dual bulkhead fittings are included for each end so water can enter from the left, right or both ends!  A plug is included to plug whichever end is not used.

Use inward curving pieces to create a concave waterfall, use outward curving pieces to create a "peninsula" with water falling off three sides or use both styles combined together to create an "S" shaped waterfall!  The straight, inward and outward pieces are  interchangeable and can be used in any combination. 

Waterfall spillways are designed to sit inside the liner eliminating any concerns of leaking.  The liner simply goes under the spillway and up the back side.  The bulkhead fitting secures liner to tub where the hose enters the spillway.

Easy bolt together assembly - no drilling needed!

Waterfall spillways have a plastic grating just below the water level that not only keeps the walls from bowing when buried in the ground, but also allows you to stack 3" - 4" of rock to hide the spillway.